3.Important: After installation is
completed, remove aerator. Turn
on water supply and allow both
hot and cold water to run for at
least one minute each. While
water is running, check for leaks.
Replace aerator.
2.Make connections to water
lines. Use 1/2" IPS faucet
connections (2A) or use coupling
nuts (2C) (not included) with
3/8"O.D.ball-nose risers (2B).
Use wrenches to tighten
connections. Do not overtighten.
1.Shut off water supplies.
Remove old faucet. Place
gasket (1A) on bottom of new
faucet. Place faucet through
mounting holes in sink. Secure
faucet to sink using mounting
nuts (1B) provided.
3
2
1
1-800-558-8700
Mequon, WI 53092
Design House is a registered
brand of DHI Corp.
TWO HANDLE
LAVATORY FAUCET
Models 523308, 523290,523282
silicon sealer
flashlight
faucet supply tubes
basin wrench
Teflon tape
(2) crescent wrenches
Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home.
Please read all of these instructions carefully before installing your new faucet.
Helpful tools to install this faucet:
IMPORTANT POINTS
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that
are too tight will reduce the integrity of the system.
Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant
are present) with Teflon tape available from your local hardware or plumbing supply store.
Always wrap in a clockwise direction.
SAFETY TIPS
ALWAYS
protect your eyes with safety glasses.
CONSUMER PROTECTION WARNING
Under the Safe Drinking Water Act, the U.S. Environmental Protection Agency restricts the
amount of lead used in brass and solder. Your new faucet is made in strict compliance with
all government standards. The materials used in the manufacture of this faucet are of industry
standard quality and are similar to other plumbing products having brass fittings.
To reduce the amount of lead in your drinking water, allow the water to run for a moment before
filling your glass and remember to always use cold water for drinking purposes.
Your new Design House faucet is designed to give you years of trouble free performance. Keep it looking
new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals
that will dull the finish and void your warranty
Brass finishes are polished, then protected with a lacquer coating to help prevent tarnishing. Clean these
surfaces only with a damp, soft cloth.
INSTALLATION PROCEDURE
MAINTENANCE
1B
1A
2A
2B
2C
