Copyright©2011 Design Gateway Co,.Ltd. All rights reserved.
FMC SATA RAID board [AB09-FMCRAID]
Manual
[Ver1.2E]
Introduction
Thank you for choosing FMC SATA RAID board [Part Number: AB09-FMCRAID] (“RAID board” in this manual.)
The RAID board is compliant with FMC standard and provides 10 SATA channels at maximum by high speed serial
interface in HPC(High Pin Count)-FMC so that user can build SATA RAID prototype system.
The RAID board mounts 5 SATA interface at both of component and solder side of the board and can directly connect with
10 2.5”-SATA drive. User can supply power to the connected SATA drive via 4-pin ATX Standard power connector.
On-board 150MHz low-jitter differential oscillator will supply high-quality reference SATA clock to the refclk input of
FPGA.
Following figure-1 shows the RAID board with 5 2.5”-SATA drives and connected FPGA board. (User can mount another
5 2.5”-SATA drives on the solder side of the RAID board so that the RAID board can support up to 10 SATA drives at
maximum.
Figure-1: AB09-FMCRAID board
