2
598-1165-03
INSTALLATION
WIRING
1.
Remove
two nuts.
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
BLACK
One Motion Light
Black
to
black
White
to
white
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the “pigtail”
with the GND screw on the mounting plate.
❒
Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green “pigtail”. If you are unsure about
the grounding method, consult your local
building code.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
WHITE
Two Motion Lights
BLACK
BLACK
WHITE
Wire
Path
Junction
Box
Screws
Fixture
Screw
Fixture
Screw
Horizontal Junction Boxes Only:
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screw holes. Wire path must be located as
shown above.
Ground
Screw
4.
Attach mounting
plate to junction box.
Wire Path
Ground
Screw
3.
Tighten screws
finger tight.
2.
Remove
Mounting Plate.
WARNING: Turn power off at circuit
breaker.
