GLASS DOOR AND RAIL INSTALLATION
INSTRUCTIONS FOR MODELS BDMO48E, BDMO48G
AND BDMO48C
DOOR RAIL AND HARDWARE INSTALLATION
IMPORTANT: Install top and bottom rails
and hardware before installing glass door
panels.
1. Remove screws securing top face to firebox
(see Figure 1).
2. Align holes on rail to be installed at top and
replace screws.
Note:
Door rails are identical
until spring clips are in place.
3. Using remaining door rail as a template, place
along front row of bricks at bottom making sure
rail front surface is flush with fireplace bottom
face surface. Mark hole centers and remove rail
(see Figure 1).
4. Drill 9 - 5/32" diameter holes about 1" deep di
-
rectly into bricks using a 5/32" concrete drill bit
(not provided).
Figure 2 - Mounting Door Retaining Clips
Retaining Clip
Top Rail
Bottom Rail
Figure 1 - Securing Door Rails to Fireplace
Bottom Rail (Use
as a Template
before Drilling)
Concrete
Screws
Top Rail
Drill Holes
into Bricks
Remove Screws
then Replace to
Secure Top Rail
Save for future reference.
5. Place rail back on bricks and align holes. Secure
using 9 concrete screws provided with glass
door kit.
6. Secure mounting clips to top and bottom rails
(see Figure 2).
INSTALLINg gLASS DOORS
After spring clips have been installed some adjust
-
ments may be needed. Install the doors using the
following steps:
1. With bi-fold doors completely folded, insert bot
-
tom pivot pin into bottom retaining clip located
at far left and far right side of bottom rail. Swing
door to vertical position making sure top pins
slide into top door rail. Door is installed when
top door pin snaps into spring clip (see Figure
3, page 2).
2. Repeat step 1 for remaining door.
