DEPURECO RAM 1000, Инструкция по эксплуатации и техническому обслуживанию

Страница: 23 / 113

Page 24 of 38
4.2 Operating cycle
Ensure that the power cord is intact and in perfect state.
Warning!
Before inserting the plug, ensure that the voltage of the power supply line
corresponds to the one indicated on the vacuum's identification plate.
- Make sure the plug is correctly inserted into the socket
- Make sure the hose is properly inserted and locked on the suction inlet.
- Secure the vacuum cleaner using the lever on the swivelling wheels
- Position the discharge hose appropriately
- Open the ball valve on the discharge nozzle
- Rotate the main switch (
1
) to “
I
”(“
ON
”) and start the vacuuming
- Lift the three switches on the motor head to start vacuuming
- Position the submerged pump on “ ON ” to initiate continuous discharge operations
- When the level of liquid inside the tank rises, a float switch connected to the submerged pump
lifts, activating it. The pump starts discharging the liquids from the tank. In the event the
maximum quantity of liquids is picked up a second float switch, connected to the electrical
board, will stop the intake, which will resume once the level of liquids inside the tank is below
the maximum one. Once done the vacuum can be switched off by turning the main switch (
1 )
to “
0
”and close the valve on the end of the discharge nozzle.
Caution!
Continuous discharge active. Ensure a container dedicated to the collection of the
discharged material is present under the hose.
Caution!
Before switching the vacuum cleaner on again make sure, the blower has come to a
complete stop.