Denyo DLW-300LS, Инструкция по эксплуатации, Страница: 19 / 50

- 17 -
(6) After the engine starts, let the machine idle 5 10 minutes to warm-up.
And the engine rotates high speed for a few seconds immediately after the engine starts,
if the
“
e Mode Selector Switch
”
is in VARIABLE or HIGH/LOW.
[ NOTE ]
[ NOTE ] [ NOTE ]
[ NOTE ] : While the engine is operating, do not turn the starter switch on.
(7) Carefully check the engine for abnormal vibration ( noise ), oil leakage,
fuel leakage, cooling water leakage and air leakage. If the machine is operating
normally, set the “Circuit breaker”to the ON position in order to supply
electricity to the load.
(8) Do not have any of the doors of the machine open while operating. The main problems
with leaving the doors of the machine open during operating, are the effect on the internal
cooling air-flow of the machine and alien substances ( e.g. dust and dirt ) will be
drawn into the machine.
(9) After the engine in started, check to see that the oil pressure lamp and battery
charging lamp are off. If one of these lamps are on, check the machine after the engine
is turned off. (Refer to the Operation Manual for details)
(10) While the engine is operating, check the Hour Meter operating. When turn the key to
the
“
Start
”
position, the Hour Meter operating.