![background image](http://html1.mh-extra.com/html/denver/wct-5005/wct-5005_instruction-manual_2484585007.webp)
ENG-7
3. Easy Operation
3.1 Power Supply
To supply power for the camera, four or eight AA size batteries are needed.
Open the bottom cover. Confirm that the power switch is at the OFF (Right)
position, pull out the battery depot. Load the fully charged batteries into the depot
according the polarities sign shown below. Push back the battery compartment to
the battery chamber.
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries (Recommended)
2. Rechargeable NiMH batteries
There are four battery slots. Slot 1 and 2 form one group (“1” will mark on depot),
while slot 3 and 4 form the other group (“2” will mark on depot) where each group
can supply the power individually.
When in Test Mode, camera will be automatically shut down to save power if
without any operation within 3 minutes; it could be waked up by any movement
detection.
When in low-battery state, camera will be also automatically shut down. Please
change the batteries in time.
3.2 Insert the SD-card
Insert SD-card into the card slot with marked side upwards.
Please note that the SD-card can only be plugged in one direction. Make sure that
the write-protect switch of the SD-
card is on the “write” position.
3.3 Power on and Enter into the ON Mode
Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances that could be construed as
animals or humans such as trees that are exposed to direct sunlight for much
of the day or any other heat source. These may cause false triggers.
2. The height from ground for placing the camera should 1 meter with the object.
For example for deer waste height is good size appropriately. In general, one
to two meters are preferred.
Slot 1
Slot 2
Slot 3
Slot 4