DENTSPLY Multimat 2 Touch, Инструкция по эксплуатации

Страница: 65 / 204

65
5.7 Start program
1. Open the firing chamber with the button “
A
” on the right sensor keypad (if not opened yet).
2. Press the sensor button “Start/Stop”. The furnace changes to the screen “Firing curve”.
The firing curve illustrates all firing steps. Initially, the firing curve is empty, and it will be filled with color during the firing sequence. Below the
firing curve the times for the individual firing steps are displayed, counting down to zero. The displayed remaining time is the estimated addition
of all partial times.
If selected in the basic settings, the printer or PC icon is displayed on the right edge of the screen.
The following functions can be selected during firing:
Function Activation
a. View Sensor button lift “
A
“
, and “
Y
“
to close again
b. Abort view Sensor button “Start/Stop”
c. Abort program Sensor button “Start/Stop”
d. Abort vacuum/view Sensor button “C”
e. Change firing parameters Sensor button “
>
”
f. Confirm messages Sensor button
“C”
g. Activate Night Mode Sensor button “Night Mode”
Programming the firing parameters is the same in all firing modes.
5.8 Standard functions
5.8.1 Opening a program
1. Press the sensor button “R” and
2. enter the program number.
3. For program numbers lower than 100, press “R” again.
4. Press the soft key “List” and browse the available programs. The desired program is directly displayed by pressing the
relevant sensor button.
5.8.2 Saving a program
Save your program by pressing the button “S”. The entered firing parameters will be checked on validity. Invalid firing parameters will be shown
in the info field and must be corrected after press-ing the button “C”. Once all firing parameters are accepted, the control system proposes to
use the next available program number as a storage location. Press the button “S” again to accept the default setting.
If you wish to save a program under an individual number, use the numeric keypad to enter a different program number and confirm with “S”.
The firing parameters will be saved. By entering a new number, the old program with this number will be over-written. You will be asked to con-
firm the overwriting.
5.8.3 Changing a program
Change your program by directly selecting the firing parameter and entering the new value with the numeric keypad.
The new value will be saved by:
a. selecting the firing parameter again or
b. selecting another firing parameter or
c. saving the program
5.8.4 Changing a program during the firing sequence
All firing sections not yet processed may be changed while firing is in progress. For this, press the button “
>
” in the firing curve screen. The
firing parameter screen is displayed. The firing process can also be observed in this screen.
Select the firing parameter to be changed, enter changed value and confirm by selecting the parameter again (see section 5.8.3 ). The yellow
sensor buttons of the processed and running firing section are masked out and cannot be changed. The change is one-time, is not saved and
is only valid for the currently running program. Press the button “
_
” to change to the firing curve screen again. After the firing is complete, the
original parameters are displayed again.