Dentsply Sirona
Operating Instructions (valid for Canada)
7 Operation
7.1 Camera warm-up time
66 37 487 D3652
D3652.201.01.21.02 03.2021
45
English
7
Operation
Make sure that the CEREC Omnicam is already connected when
starting
"CEREC SW". Subsequent disconnection and re-connection is
then possible without having to restart the
"CEREC SW".
7.1
Camera warm-up time
When switching on the system, the camera needs to warm up for 15 -
20 minutes. If the coated sapphire glass of the Omnicam is not
sufficiently warm, it may steam up during the acquisition. As such, it is
not possible to carry out the exposure.
Following use, always position the Omnicam on the heater plate.
You can set the end temperature to which the camera heater warms the
Omnicam mirror sleeve.
1.
In the software, navigate to the system menu and click on the
"Configuration" button.
2.
Click on the
"Devices" button.
3.
Click on the
"Omnicam" button.
4.
Click on the
"Camera Heater Settings" button.
5.
Use the slider to adjust the temperature.
7.2
Adjusting the CEREC Omnicam
You can adjust the CEREC Omnicam in the device configuration.
1.
In the software, navigate to the system menu, and click on the
"Configuration" button.
2.
Click on the
"Devices" button.
3.
Click on the
"Omnicam" button.
Accepting settings
➢ Click on the
"Ok" button.
Discarding settings
➢ Click on the
"Cancel" button.