Dentsply Sirona CEREC AC, Руководство по эксплуатации, Страница: 40 / 92

7 Operation
7.1 Camera warm-up time Dentsply Sirona
Operating Instructions CEREC AC Connect
40
64 32 087 D3492
D3492.201.07.24.02 07.2018
7
Operation
7.1
Camera warm-up time
When switching on the system, the camera needs to warm up for 15 -
20 minutes. If the coated sapphire glass of the Omnicam is not
sufficiently warm, it may steam up during the acquisition. As such, it is
not possible to carry out the exposure.
Following use, always position the Omnicam on the heater plate.
You can set the end temperature to which the camera heater warms the
Omnicam mirror sleeve.
1. In the software, navigate to the system menu and click on the
"Configuration" button.
2. Click on the "Devices" button.
3. Click on the
"Omnicam" button.
4. Click on the "Camera Heater Settings" button.
5. Use the slider to adjust the temperature.
7.2
Adjusting the CEREC Omnicam
You can adjust the CEREC Omnicam in the device configuration.
1. In the software, navigate to the system menu, and click on the
"Configuration" button.
2. Click on the "Devices" button.
3.
Click on the
"Omnicam" button.
Accepting settings
➢ Click on the "Ok" button.
Discarding settings
➢ Click on the "Cancel" button.