Denso BHT-1260BWB-CE, Руководство пользователя

Страница: 168 / 251

156
BHT-1200 Series
4.7 WWAN Manager
"WWAN Manager" is a wireless WAN setup tool to connect the BHT via a wireless wide area network.
4.7.1 WWAN Manager menu
To open the WWAN
Manager, double tap the “Wireless WAN” icon in the
System Properties.
The WWAN Manager provides the following menus.
General: Turns ON or OFF the WWAN module,
connect or disconnect data connection,
displays connection status
Data Connection : Sets up data connection
Security : Authenticates the PIN,
enables or disables the SIM PIN, changes the PIN
Bands : Displays available frequency bands
Info : Displays the IMSI and IMEI information
Ping: Checks the WWAN communication status
- Note -
Data connection started by the WWAN manager will be disconnected when the
WWAN manager is closed.
Do not close the WWAN manager if data connection is needed to be ON.
The power status of the WWAN module will not be changed by closing the WWAN
manager.
- Note -
When replacing the battery, remove the battery cover after turning off either the
WWAN module or the BHT.
- Note -
The WWAN module may take some time to turn back ON if turned ON immediately
after turning OFF.
- Note -
When turning on and off the BHT while the WWAN module is ON, wait at least 30
seconds after turning off the BHT before turning it back on again.
- Point -
If the WWAN module is ON at reset (warm boot), the WWAN module will be turned
ON after reset (warm boot)