Gateway Lite
.
Installation Guide
v1.0
GWL-9201-1
Warning! Always make sure that your vehicle’s
battery is disconnected before beginning
installation and that you have your head unit’s
(radio’s) security code (if applicable).
Remove the head unit
First, carefully remove your vehicle’s existing OE
head unit as per the factory instructions and
using the correct tools.
In some cases, removing the head unit will
require panel removal. Contact your vehicle’s
dealer or installation supplier/installer for more
information.
Remove antenna and wiring connector
Once the head unit has been removed,
disconnect the antenna cable (1), then unclip the
main wiring connector from the head unit (2). This
again, will differ in all makes and manufacturers.
Connecting the cable harness
With the main radio cable removed, first connect
the Dension supplied cable to the original factory
cable harness.
In some cases there may be an add-in connector.
Remove the CD changer section and replace with
the loom supplied with the Gateway Lite. Turn
page over for car-specific connections.
Connect iPod connector and USB
Connect the round iPod connector and USB to
the module and feed them through the dashboard
to an appropriate location.
Warning! Do not trap the cables, or leave
them in a position where they may become
trapped after refitting the head unit.
Ensure the device is correctly fitted before
running the cable. Then, reconnect the Dension
supplied main radio connector to the rear of the
head unit.
2
Connecting the gateway
1
Head unit disconnection
