Denon SC5000 PRIME, Руководство пользователя, Страница: 23 / 37

23
Playback & Cueing
To play or pause a track , press Play / Pause (

/

).
To scratch a track , press Vinyl so it is lit brightly and then move the platter .
To set the initial cue point , press and hold Shift and press Cue at the desired location during playback.
To return to the initial cue point and stop , press Cue . The button will flash while the unit is paused at the cue
point.
To return to the initial cue point and keep playing , press and hold Shift and press Play / Pause (

/

).
To reverse playback , press and hold Shift and press Censor / Reverse . The button will flash while playback
is reversed.
To return to normal playback , press Censor / Reverse .
To censor playback , press and hold Censor .
To return to normal playback , release Censor . Normal playback will resume from where it would have
been if you had never engaged the Censor feature (i.e., as if the track had been playing forward the whole
time).
To skip to the previous or next track , press one of the Track Skip

/

buttons.
To return to the beginning of a track , press Track Skip

in the middle of a paused track.
To scan quickly through the track , press and hold Shift and then press one of the Track Skip buttons.
To enable or disable Slip Mode , press Slip . In Slip Mode, you can jump to cue points, use the platters, or
pause the track while the track’s timeline continues (the lower half of the waveform in the touchscreen will
continue moving forward). When you stop whatever action you are performing, the track will resume normal
playback from where it would have been if you had never done anything (i.e., as if the track had been playing
forward the whole time).
To jump to a specific location in the track :
•
If Needle Lock is disabled : tap the desired location in the track overview.
•
If Needle Lock is enabled : pause playback and then tap the desired location in the track overview.
Alternatively, make sure the platter is in Vinyl Mode (press Vinyl so it is lit), touch the top of the
platter , and tap the desired location in the track overview. See Control Center > User Profile to
learn about Needle Lock.
To zoom in and out of the waveform , place two fingers on the display and spread them apart or pinch
them together. Alternatively, turn the Select / Load knob.
Looping & Beat-Jumping
To create and activate an auto loop , press the Auto Loop knob.
To set the auto loop length , turn the Auto Loop knob to select the number of beats: 1 / 32 , 1 / 16 , 1 / 8 , 1 / 4 ,
1 / 2 , 1 , 2 , 4 , 8 , 16 , 32 , or 64 .
To create and activate a manual loop , press Loop In to set the start point, and then press Loop Out to set
the end point. The loop will be activated immediately, and the loop will be indicated as a shaded area in
the waveform and track overview.
To deactivate a loop , press the Auto Loop knob.
To move the loop , press and hold Shift and turn the Auto Loop knob while the loop is activated.
To double or halve the length of a loop , turn the Auto Loop knob while the loop is activated.
To manually edit the beginning or end of a loop, press Loop In or Loop Out , respectively, and then move
the platter left or right to shorten or extend the loop region. Commit the edit by pressing Loop In or Loop
Out again.
To beat-jump through a track , press one of the Beat Jump buttons. Each press will skip through the track
by the set length. You can adjust the beat jump length by pressing and holding Shift and pressing either
button.