Denon PRIME GO, Руководство пользователя, Страница: 19 / 30

19
Pad Modes
The performance pads on each deck have different functions in each pad mode.
To enter each pad mode , press the corresponding button: Hot Cue , Loop , or Roll .
Hot Cue Mode
In Hot Cue Mode, you can use each pad to jump to an assigned hot cue point.
Tip : You can use the Engine Prime software to set, name, and assign colors to your hot cue points. The names and
colors will appear in the display for reference.
To assign a hot cue to a pad , press a dimly lit pad at the desired location in the track. The pad will light up when a hot
cue point is assigned.
To jump to a hot cue point , press the corresponding pad.
To clear a hot cue from a pad , press Shift and the desired pad. The pad will become dim when there is no hot cue point
assigned to it.
To access hot cue points 5-8 , press the Bank button so that it is flashing. To return to hot cue points 1-4, press the
Bank button again so that it becomes solidly lit.
Loop Mode
In Manual Loop Mode, you can use each pad to activate an assigned loop.
Tip : You can use the Engine Prime software to set and name your loops. The names will appear in the display for
reference.
•
To assign a loop to a pad and activate it , press a dimly lit pad to create a Loop In point at the current location,
and then press it again to create the Loop Out point at another location. You can also assign an auto loop to a pad
by pressing a dimly lit pad while in the auto loop. The loop will activate immediately, and the pad will light up.
•
To activate a loop , press the corresponding pad.
•
To delete a loop , press Shift and the desired pad.
•
To access loops 5-8 , press the Bank button so that it is flashing. To return to loops 1-4, press the Bank button
again so that it becomes solidly lit.
In Auto Loop Mode (second press), you can use each pad to create and activate an auto loop. Pressing Loop while in
manual loop mode will enter Auto Loop Mode.
•
To activate an auto loop , press a pad. The touchscreen will show the length of the auto loop for each pad.
•
To deactivate an auto loop , press the pad again.
•
To move the active loop to the left or right (Loop Move), press and hold Shift and turn the Auto Loop knob.
•
To access auto loops 5-8 , press the Bank button so that it is flashing. To return to auto loops 1-4, press the Bank
button again so that it becomes solidly lit.
Roll Mode
In Roll Mode, you can press and hold each pad to trigger a “loop roll” of a certain length while the track’s timeline continues
(the lower half of the waveform in the display will continue moving forward). When you release the pad, the track will resume
normal playback from where it would have been if you had never done anything (i.e., as if the track had been playing
forward the whole time).
To trigger a roll , press the corresponding pad. Pads with triplet-based loop rolls are lit purple.
To access rolls 5-8 , press the Bank button so that it is flashing. To return to auto loops 1-4, press the Bank button
again so that it becomes solidly lit.