Denon DRA-100, Руководство по обслуживанию

Страница: 11 / 98

CAUTION IN SERVICING
Initializing This Unit
Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the digital PCB.
1. Press the power operation button "
X
" to turn off the power, and remove the AC plug from the socket.
2. Insert the AC plug into the socket while pressing and holding the "
WPS
" and "
iOS
" buttons on the rear panel.
(Factory Reset)
3. Press the power operation button "
X
" to turn off the power, and remove the AC plug from the socket.
4. Insert the AC plug while pressing the power operation button"
X
". (Starts in Special mode.)
5. Press the "
CURSOR
d
" button, and press the "
Enter
" button on the "
Initialize
" display.
(Initialized)
6. Wait for more than 90 seconds after "
Initialized
" is displayed and then turn the power off.
(During this time, start and initialize the network devices.)
NOTE： • If the unit fails to enter the service mode in step 6, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down your settings in advance and
reconfigure the settings after initialization.
CURSOR
X
iOS WPS
11