Network
To use this unit by connecting it to a home network (LAN), you must configure network settings. If you set up your home network via DHCP, set “DHCP” to
On (use the default setting). This allows this unit to use your home network.
If you assign an IP address for each device, you must use the “IP Address” setting to assign an IP address to this unit and enter the information about your
home network such as the gateway address and subnet mask.
Network Information
Display network information.
Friendly Name / DHCPOn
or
Off / IP Address / MAC Address / SSID
z
z
This is displayed only while a Wi-Fi connection is enabled.
Network Control
Enables network communication in standby power mode.
On:
The network function can be used when in
standby power mode. Main unit operable
with a network compatible controller.
Off
(Default)
:
The network function cannot be used in
standby power mode.
Set to “On” when using the web control function or a network compatible controller.
NOTE
0
When “Network Control” is set to “On”, the unit consumes more standby power.
66
