ENGLISH
Connections
Pl
ayback
Troubl
eshooting
Specifications
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
•
When traveling or leaving home for long periods of time, be sure to
unplug the power cord from the power outlet.
• Sufficiently ventilate the place of installation
If the unit is left in a room full of the smoke from cigarettes, etc.,
for long periods of time, the surface of the optical pickup could get
dirty, in which case it will not be able to read the signals properly.
• About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units
before moving the unit.
•
Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Cautions on Handling
Discs Usable on the DCD-710AE
Discs
q
Music CDs
Discs marked with the logotype below can be played in
this unit.
w
CD-R/CD-RW
NOTE
• Discs with special shapes (heart-
shaped discs, octagonal discs,
etc.) cannot be played. Do not
attempt to play them, as doing so
can damage the product.
• Some discs and some recording formats may not be playable.
• Non-finalized discs cannot be played.
b
What is finalization?
Finalization is the process that makes recorded CD-R/CD-RW discs
playable on compatible players.
Do not touch the signal surface.
Holding Discs
• “00 Tr 00 : 00” is displayed if a disc that cannot be played is
loaded.
• “NO DISC” is displayed if the disc is loaded upside-down or if no
disc is loaded.
Cautions on Loading Discs
• Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
• Do not use discs on which the sticky part of cellophane tape or
labels is exposed or on which there are traces of where labels have
been removed. Such discs can get caught inside the player and
damage it.
Figure 1
•
Set the disc with the labeled side facing up.
•
Make sure the disc tray is fully open when inserting the disc.
•
Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),
8 cm discs in the inner tray guide (Figure 2).
Loading Discs
12 cm disc
8 cm disc
Outer tray guide
Inner tray guide
Figure 2
•
Place 8 cm discs in the inner tray guide without using an adapter.
Check that the following parts are supplied with the product.
q
Owner’s manual ...................................................................... 1
w
Service station list ................................................................... 1
e
Remote control unit (RC-1133) ............................................... 1
r
R03/AAA batteries ................................................................... 2
t
Audio cable (Cord length: Approx. 1.0 m) .............................. 1
r
t
e
Accessories
NOTE
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
Getting Started
