Denon AVR-X7200W, Руководство по обслуживанию

Страница: 75 / 278

4. Remote ID Setup Mode
4.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are used in the same
room.
4.2. Starting up
Hold down buttons " STATUS " and " ZONE3 SOURCE " at the same time and press the power button to turn on the power.
Select the " 6. REMOTE ID " using the button " CURSOR
f
", and press the button " ENTER " to commit the selection.
4.3. Operations
(1) When Remote ID Setup mode is started, the following is displayed.
FLD
L1
L2
R E M O T E I D ?
(2) Press the "
QUICK SELECT 1 - 4
" button that corresponds to the number you want to set.
Button Display
QUICK SELECT 1 L2
R E M O T E I D 1
QUICK SELECT 2
L2
R E M O T E I D 2
QUICK SELECT 3 L2
R E M O T E I D 3
QUICK SELECT 4 L2
R E M O T E I D 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
b
Only " QUICK SELECT 1 - 4 " and the POWER button on the unit can be used in Remote ID Setup Mode.
4.4. Setting the Remote coutrol unit
(1) Press and hold " RC SETUP " button for more than 3 seconds.
(2) Use "
d
/
f
" to display "
RC-ID
" on the remote control unit and press "
ENTER
".
(3) Use "
d
/
f
" to set the remote ID and press " ENTER ".
" OK " flashes four times on the remote control unit and the normal operation mode is restored.
NOTE:
If the ID of the unit and remote control do not match, " AVAMP
z
" appears on the display of the unit when the remote
control is used (*: own remote control ID).
75