Symptom
Cause / Solution
Page
DTS Neural:X mode cannot
be selected.
0
DTS Neural:X cannot be selected when using the headphones.
-
Dolby Surround mode
cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
-
Audyssey MultEQ
®
XT,
Audyssey Dynamic EQ
®
and Audyssey Dynamic
Volume
®
cannot be
selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
186
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
125
0
These cannot be selected when using the headphones.
-
“Restorer” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
160
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
125
No audio is output from
PRE OUT or speakers for
ZONE2.
0
In ZONE2, the audio can be played back when signals input from digital connectors (OPTICAL/
COAXIAL) are in 2ch PCM format.
-
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
format. To play back the audio in ZONE2 irrespective of the input signal format, set “HDMI Audio” in the
menu to “PCM”. Depending on the played back device, the audio may not be played back even with this
setting. In that case, set the audio format to “PCM (2ch)” on the played back device.
220
0
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
-
Contents
Connections
Playback
Settings
Tips
Appendix
237
Front panel
Display
Rear panel
Remote
Index
Downloaded from
www.Manualslib.com
manuals search engine