Press and hold the “
DIMMER
" button for 3 seconds.
Press and hold the “
DIMMER
“ button again for 3 seconds and
“CLEAR” is displayed followed by “NO PROTECT”. The unit’s
Protection History is now cleared.
Clearing the Protection History
If the unit is in “Protection History Display Mode”, just press and hold the “ENTER” button for 3 seconds.
Note:
If you do not mind erasing your settings from this unit, you can
also “Initialized/Micro Reset the unit to clear the Protection History from the unit’s memory.
If the unit is not in “Protection History Display Mode”,
enter the “Protection History Display Mode”:
1. Hold down buttons “
TUNER PRESET CH-”, “TUNE-” and “TUNER PRESET CH+”
at the same time and press the
“POWER”
button to turn on the power.
2. Select "
PROTECTION
" using the “
TUNER PRESET CH+/-
“ buttons, and press the “
STATUS
" button.
3. Press the "
STATUS
" button again and the unit will display the Protection History condition.
FLD
P
R
T
:
D
C
FLD
P
R
T
:
C
L
E
A
R
FLD
N
O
P
R
O
T
E
C
T
Warning Displays by POWER LED
If the power is turned off while a protection is detected, the POWER LED (red) flashes in the following ways as a warning according to the protection status.
(a) ASO/DC protection: Flashes in 0.5-second cycles (0.25 seconds lit, 0.25 seconds unlit)
(b) THERMAL (A/B) protection: Flashes in 2-second cycles (1 seconds lit, 1 seconds unlit)
AVR-S700W (3 of 3)
PROTECTION HISTORY DISPLAY MODE
