131
Remote control unit
Inserting the batteries
q
Remove the rear lid in the
direction of the arrow and
remove it.
w
Load the two batteries properly
as indicated by the marks in the
battery compartment.
R03/AAA
e
Put the rear cover back on.
NOTE
•
Insert the specified batteries in the remote control unit.
•
Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit. (The
supplied batteries are only for verifying operation. Replace them
with new batteries at an early date.)
•
When inserting the batteries, be sure to do so in the proper direction,
following the
q
and
w
marks in the battery compartment.
•
To prevent damage or leakage of battery fluid:
•
Do not use a new battery together with an old one.
•
Do not use two different types of batteries.
•
Do not attempt to charge dry batteries.
•
Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
•
Do not keep the battery in a place exposed to direct sunlight or in
places with extremely high temperatures, such as near a heater.
•
If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
•
Remove the batteries from the remote control unit if it will not be in
use for long periods.
•
Used batteries should be disposed of in accordance with the local
regulations regarding battery disposal.
•
The remote control unit may function improperly if rechargeable
batteries are used.
Operating range of the remote control unit
Point the remote control unit at the remote sensor when operating it.
30°
30°
Approx. 23 ft/7 m
NOTE
•
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or
infrared light.
•
When using 3D video devices that transmit radio communication
signals (such as infrared signals etc) between the various units (such
as the monitor, 3D glasses, 3D transmitter unit etc), the remote
control unit may not operate due to interference from those radio
communication signals. If this occurs, adjust the direction and
distance of the 3D communication for each unit, and check that the
remote control unit operation is not affected by these signals.
Specifying the zone used with the remote
control unit
When the
ZONE2
button is pressed, only the MAIN ZONE can be
operated with the remote control unit.
Press and hold
ZONE2
and
SETUP
.
MAIN
and
ZONE2
button blink.
n
To cancel
Press and hold
ZONE2
and
SETUP
.
MAIN
and
ZONE2
button blink.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Inf
or
mation
