WARN INDUSTRIES
PAGE 6
70208A2
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
FAILURE TO SECURELY TIGHTEN ALL BOLTS
ON THE WINCH PLATE, WINCH, AND FAIRLEAD
CAN RESULT IN PRODUCT FAILURE WHICH
MAY RESULT IN VEHICLE DAMAGE AND OP-
ERATOR INJURY OR DEATH. DOUBLE CHECK
THAT ALL BOLTS ARE SECURELY TIGHTENED
PRIOR TO USE.
WARNING
Figure 7 Complete Winch Installation
Clevis Hook
Front Skid Plate
IV. Specific KVF750 Wiring Instructions
IT SHOULD BE NOTED THAT THE FOLLOWING
INSTRUCTIONS ARE UNIT SPECIFIC. THE
FOLLOWING INSTRUCTIONS SHOULD BE
REFERRED TO AS REFERENCE INSTRUCTIONS
TO ASSIST WIRING THE WINCH FROM THE
INSTALLATION AND SPECIFICATION GUIDE
SUPPLIED IN THE WINCH KIT.
Notice
WARNING
AVOID ALL MOVING AND POTENTIALLY HOT
COMPONENTS OF ATV WHEN ROUTING
ELECTRICAL CABLES. AVOID AREAS WHERE
THE WIRING COULD BE PINCHED WHEN
COMPONENTS ARE REINSTALLED. FAILURE
TO DO SO CAN RESULT IN PRODUCT
FAILURE WHICH CAN LEAD TO VEHICLE
DAMAGE AND OPERATOR INJURY OR DEATH.
1. Wiring Contactor Installation
a.
Remove seat shown in Figure 11.
b.
Remove air filter cover shown in Figure 12.
c.
Remove the battery cover shown in Figure 13.
d.
Remove cover under handlebars shown in
Figure 14.
Figure 11
