background image

866.527.7637 

[email protected]

 

 

 

 

DENALI Plow Mount 

MA11110 

Polaris Sportsman

 

 

Thank you for purchasing our DENALI plow mount. You now own a premium custom 
plow mount to allow you to use your plow with your ATV. Please note the following 
instructions and heed all warnings. 
 

  Your ATV and/or plow system can cause death or injury, please use caution and 

common sense when operating your unit. 

  Read your Plow Operator Manual, your Winch Operator Manual, and all warning 

labels before operating your ATV. 

  Operate your ATV at a walking speed with the blade installed. Do not exceed 5 

mph (8 km/h), even with the blade up. 

  Do not operate the ATV on slopes greater than 10 degrees with the plow 

installed. 

  Always lower the plow to the down position before leaving your ATV unattended. 

 

SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.   

 

Содержание MA11110

Страница 1: ...use death or injury please use caution and common sense when operating your unit Read your Plow Operator Manual your Winch Operator Manual and all warning labels before operating your ATV Operate your ATV at a walking speed with the blade installed Do not exceed 5 mph 8 km h even with the blade up Do not operate the ATV on slopes greater than 10 degrees with the plow installed Always lower the plo...

Страница 2: ... motoinfo motoalliance com Please verify that all hardware and parts are included in your package Kit Contents Item Number Description Quantity 1 Base Plate 1 2 MA11110 Rear Strap 1 3 2 Serrated Hex Bolt 92323A563 1 4 3 8 x 1 Serrated Hex Bolt 92323A554 4 5 3 8 Serrated Flange Nut 95922A130 5 ...

Страница 3: ...the Sportsman 1000 frame just behind the Drive Shaft U Joints as shown in Figure 2 Orient the Rear Strap so that the angled bends match the angles of the frame It may be necessary to remove one of the plastic fender clips on the right hand side of the vehicle to maneuver the Rear Strap into position Once the Rear Strap is positioned replace the plastic clip Figure 2 ...

Страница 4: ...the 3 8 x 2 1 4 Serrated Flange Bolt into the middle hole at the top of the Rear Strap Install one of the 3 8 Serrated Flange Nuts but do not tighten at this time 3 Install the remaining four 3 8 x 1 Serrated Flange Bolts from the top of the Rear Strap secure with the remaining four 3 8 Serrated Flange Nuts Tighten all the bolts at this time 4 Install the plow mount per the manufacturer s instruct...

Отзывы: