Demix TEKHMANN TSC-1885, Руководство пользователя

Страница: 24 / 43

24

insert a thin piece of wood into the back end of the saw blade base and mark the position on the
base;

move the wood with the mark to the front of the base and turn the adjusting screw so that the mark
would correspond the base side;

after adjusting tighten all mounting screws.
NOTE:
Parallelism may be disturb if cutting depth will be adjusted after adjusting parallelism. Never
unscrew the sleeve screws.
CUTTING PROCEDURES
1. Place the saw body (base) on the work piece, and align the intended line of cut with the saw blade,
using the notch at the front of the base. This relationship of base to work pieces should remain
unchanged regardless of the inclination of the base.
2. The switch should be turned to the ON position before the saw blade comes into contact with the
work piece. T
he switch is turned ON when the trigger is pulled by one’s finger, and is turned OFF
when the trigger is released.
CAUTION!
Before cutting check the material to be cut.
Before starting to saw, ensure that the saw blade has reached full speed revolution. Should
the saw blade be stopped or make an abnormal noise during operation, turn off the switch
immediately.
Always take care in preventing the power cord from coming near the revolving saw blade. Wear eye
protection. After operation disconnect the plug from the receptacle.
Mounting and dismounting the saw blade
WARNING! To avoid serious accident ensure the switch is in the OFF position, and
disconnect the plug from the receptacle.
3. Dismounting the saw blade:

set the cutting volume at maximum, and place the Circular Saw;

depress the lock lever, lock the spindle, and remove the hexagonal-flange bolt and washer with
the wrench;

while holding the lever to keep the lower guard fully retracted into the blade cover, remove the saw
blade.
4. Mounting the saw blade

thoroughly remove any sawdust which has accumulated on the spindle, bolt and washers;

for mounting saw blade, the concave sides of both washers (A) and (B) must be fitted to the saw
blade sides. Mount the saw blade on the spindle, and finally affix washer;

to assure proper rotation direction of the saw blade, the arrow direction on the saw blade must
coincide with the arrow direction on the blade cover;

using the fingers, tighten the hexagonal bolt retaining the saw blade as much as possible. Then
depress the lock lever, lock the spindle, and thoroughly tighten the bolt;

confirm that the lock lever is in the original position.
MAINTENANCE AND INSPECTION
1. Inspecting the saw blade
Since use of a dull saw blade will degrade efficiency and cause possible motor malfunction, sharpen
or replace the saw blade as soon as abrasion is noted.
2. Inspecting the mounting screws.
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure to do so could result in serious hazard.
3. Maintenance of the motor.