Demix TEKHMANN TSC-1885, Руководство пользователя

Страница: 23 / 43

23
TECHNICAL SPECIFICATIONS
Model TSC-1885
Maximum power 1800 W
Rated voltage 220 V
Rated frequency 50 Hz
Spindle speed 5800 rpm
Saw blade diameter 185 mm
Cutting depth
(90°/45°)
65 mm / 42 mm
Weight net/gross 4.1 kg / 4.35 kg
PRIOR TO OPERATION
1. Power source.
Ensure that the power source to be utilized conforms to the power requirements specified on the
product nameplate.
2.
«On\Off» switch.
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool will start operating immediately, inviting serious
accident.
3. Extension cord.
When the work area is removed from the power source. Use an extension cord of sufficient thickness
and rated capacity. The extension cord should be kept as short as practicable.
4. Prepare a wooden workbench.
Since the saw blade will extend beyond the lower surface of the work piece, place the work piece on a
workbench when cutting. If a square block is utilized as a workbench, select level ground to ensure it
is properly stabilized. An unstable workbench will result in hazardous operation.
CAUTION! To avoid possible accident, always ensure that the portion of work piece
remaining after cutting is securely anchored or held in position
частного
ADJUSTING THE SAW PRIOR TO OPERATION
1. Adjusting the cutting depth
To adjust the cutting depth loosen the lever and, while holding the base with one hand, move the main
body up and down.
WARNING! If the lever is loose, injury can result. Tighten it securely after adjustment.
2. Adjusting the level of inclination
By loosening the lever the saw blade may be inclined to an angle of 45° in relation to the base.
3. Regulating the guide
Position of the guide can be moved left and right. The guide can be installed either from the left or the
right side of the main body.
4. Fine adjustment of parallelism
For fine adjustment of saw blade parallelism in relation to base use the adjusting screw. The
adjustment will be performed by the manufacturer. Perform the following actions:

unscrew mounting screws of the cover only. Do not unscrew the sleeve screws;

pull the protecting cover into the blade cover;