DEMAG DC-Com 1, Руководство по эксплуатации

Страница: 78 / 116

8.5.5.7 Replacing the chain set
Fig. 47
Before starting any maintenance work, switch the hoist off and secure it against reconnection to the power supply.
To replace the chain set, proceed as follows:
1. Open and remove service cover (1).
2. Place bag (2) with the control cable on the chain hoist; pull out mains cable union (3) with fitted mains cable
(4) and place to one side; if a travel drive is fitted, remove the connecting cable from the strain relief arrange‐
ment;
3. Loosen cap (5) with a screwdriver (lever off);
4. Remove chain collector box (6) and set it down (

"Removing the chain collector box", Page 71);
78
214
80
2 44/291
113