H4KFWSD08DPX User Manual
3
/
26
4.1
Camera working standalone with the built-in 4KView software.
For this application, apart from the microscope, you only need an HDMI monitor, the supplied USB
mouse, and the camera embedded
4KView
software. A computer or a network connection is not required
to operate the camera in this mode. The steps to start the camera are listed below:
Figure 7-1 H4KFWSD08DPX Camera with the HDMI Displayer
Connect the camera to a HDMI displayer using the HDMI cable
.
Insert the supplied USB mouse to the camera’s USB port (USB mouse port).
Insert the supplied SD card/USB flash disk (USB3.0 interface) into the HDMI camera SD card
slot/USB3.0 interface.
Connect the camera to the power adapter and switch it on.
