Environmental Health and Safety | 2408 Wanda Daley Drive | Ames, IA 50011-3602 | Ph: (515) 294-5359 | www.ehs.iastate.edu
Reviewed 2019
Delta 12” Compound Miter Saw
Description
Compound Miter Saw – Model 36-255L
Size / Horse power
12” Blade / 5000 RPM
Power source
120 volts through plugged power cord
Uses
Cutting wood and non-ferrous metals
Safety Precautions
Hazards
Severe cuts, potential for amputation
Flying debris (potential eye and face damage)
Electrical shock
Entanglement of hair, jewelry, or clothing
Material kickback
Training
Shop Safety Fundamentals
Site Specific Training
Protective Equipment
Safety Glasses
Hearing Protection
Tie back long hair
Avoid loose fitting clothing
Remove rings, watches, bracelets, and other such jewelry
Operation
Startup
1. Put on PPE listed above
2. Ensure work area is clean and free of obstacles
3. Ensure all guards are present and function properly
4. Make necessary adjustments for safe operation
5. Inspect tool for damage or obstructions to operation
6. Set miter angle by rotating the lock knob counterclockwise and lifting up on
the miter lock lever, rotate saw table to desired angle. Lock miter angle position
by pushing down on the miter lock lever and turning the lock knob clockwise
7. Turn on saw by depressing the power switch (A) located in the handle
8. Slowly bring the blade down to the material being cut, avoid feeding the blade too
quickly
9. Keep hands clear of spinning blade
Shutdown
1. Disengage power switch
2. Return saw to upright position and allow blade to stop rotating. Blade brake should
stop the blade in 5 seconds
3. Remove work piece
4. Lower arm and lock blade in the down position, using the lock down pin
Note: The hole in the trigger is provide for a 3/16” diameter padlock (B) to be inserted
to lock the saw in the OFF position