Delta Three Phase 1342457 06-03-05, Инструкция по эксплуатации

Страница: 8 / 28

8
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE - 1-2 hours
* M6 Allen wrench (supplied) * Flathead Screwdriver (Not Supplied
* Forklift and Lifting Straps For Set-Up (Not Supplied)
UNPACKING AND CLEANING
Remove the bolts that fasten the machine to the ship-
ping skid.
Two lifting lugs are built into the machine, one of which
is shown at (A) Fig. 4. These lugs can be used to
mechanically lift the machine using a forklift and lifting
straps.
NOTE: The other lifting lug is located at the rear
and the opposite end of the machine. Carefully remove
the planer from the shipping skid.
Thread handle assembly (A) Fig. 3, into handwheel (B)
and tighten locknut (C).
If it is necessary to lower the table (B) Fig. 4, to facilitate
cleaning, loosen lock knob (C) and turn handwheel (D)
counterclockwise until the table (B) is at the desired
height for cleaning.
With allen wrench supplied, loosen and remove screw
(E) Fig. 5, from the left top edge of the machine and raise
the top cover (F) Fig. 6 as shown, exposing the chip-
breakers, and cutterhead.
NOTE: The top cover of the
machine is hinged to facilitate cleaning and performing
maintenance and adjustment procedures.
Carefully remove the protective coating from the table,
table rollers, infeed roller, anti-kickback fingers, cutter-
head and cutterhead knives. This protective coating may
be removed with a soft cloth moistened with kerosene.
(DO NOT USE GASOLINE, ACETONE, OR LACQUER
THINNER FOR THIS PURPOSE)
. CAUTION: Extreme
care should be taken when cleaning the knives as
the cutterhead knives are positioned in the cutter-
head and are very sharp
.
After cleaning, cover the table surface with a good qual-
ity paste wax.
Lower top cover and replace locking screw which was
removed in
STEP 5 .
Fig. 3
Fig. 6
Fig. 5
Fig. 4
E
C
A
D
B
F
C
A
B