Dear customer,
Thank you very much for purchasing high-qualily, energy-saving and modern ceramic heating system of the company
TELPOD. We hope you will enjoy our product. If you are not satisfied with the product or if there are reasons for a
complaint, please do not hestitate to contact us.
Attention
Please read this Instruction manual carefully before installing and commissioning this ceramic heating system, Please
note that we will not assume any liability for damage that occurred due to non-observance of this manual or due to
misuse.
Safety instructions
1. The electronically controled heating unit type Delta K240 must only be used in waterbeds with a minimum filling
height of 15cm.
2. The heating unit must only be operated with AC 220-230 V.
3. It is recommended not to connect the heating unit to the mains supply unless the mattress has been filled with
water. If you would like to pump down the water, disconnect the heating unit from the mains supply first.
4. This heating unit should not be used for medical treatment.
5. You must not replace the connecting cable. If a defect on the cable occurs, the entire heating unit must be replaced.
6. Needles and sharp edges should not come in contact with the waterbed.
7. Pillows and bedcovers should not be in contact with the heatingpads.
8. The device can be used by children of 8 years old and over, by people with reduced sensory and mental capabilities
or by people with no knowledge and experience, provided they are under supervision or they were instructed on how
to use the equipment and they know the risks related to it. Children must not play with the device. Cleaning and
maintenance must not be done by chidren, if they are not supervised.
Heating-up
We recommend that the waterbed is filled with hand-hot water (approx.
28°C). When you fill the waterbed with cold
water, excessive amounts of air bubbles and condensation water may build up. In addition to this, the heating unit
will take much longer to heat the water in your waterbed to the required temperature. If no hot water is avaliable
for filling the waterbed, the heating-up time will be accordingly extended. The heating-up of the water in your
waterbed depends on the water volume and the ambient temperature and is on
average 0.5°C to 1°C per hour.
Operation
Please keep in mind that you need two heating units in so-called DUAL waterbeds.
1. Position the ceramic heating unit in the base area of your waterbed with a distance of approx. 10cm to the
foot, lightly to the comer of the respective watermattress (in case of the DUAL system).
2. Please make sure that the cable of the heating unit is not pinched between the base unit and the mattress base.
3. The heating unit is completely positioned below the safety liner of the watermattress. Please make sure that no
folding of the vinyl takes place above the heating unit and that the surface remains smooth.
4. Use the regulating switch of the thermostat to set the required temperature according to your personal
preferences, The Indicator lamp will flash when the heating unit is heating up; it go out automatically when the
desired temperature is reached.
3
delta K160 / K240
delta k
HEIZSYSTEME
EN
–
User Manual
English
