Delta IED-S Series, Руководство пользователя

Страница: 360 / 417

Chapter 12 Descriptions of Parameter Settings | IED-S
12-13-1
Chapter 12 Descriptions of Parameter Settings
13 Drive Parameters

: You can set this parameter during operation.
Drive Software Version
Default: #.##
Settings Read only
 Drive’s released firmware version
Control Mode
Default: 0
Settings 0–8
3: FOC vector c Encoder (FOCPG)
8: FOC Permanent Motor control (FOCPM)
 Mode selection:
Settings
Control
Mode
Applicable
Motor Type
Speed
Feedback
Energy-
saving
Tuning
Difficulty
Ride
Comfort
Speed
Control
Range
Motor
Parameter
Tuning
Basic
Control
Speed
Control
3 FOCPG IM
✓
High High Good 1:1000
✓
Vector
control
Frequency
Control
8 FOCPM PM
✓
High High Good 1:1000
✓
Vector
control
Frequency
control
 Determines the control mode of the drive.
3: To increase torque and the accuracy of the speed control (1:1000).
8: To increase torque and the accuracy of the speed control (1:1000).
 Note: Pr.13-04–Pr.13-09 are automatically cleared if you change the control mode.
Drive Output Direction
Default: 0
Settings 0–1
0: The same as the setting direction
1: Opposite to the setting direction
 Use this parameter when elevator running direction is opposite to the command direction.
 If the elevator running direction is opposite to the setting direction, you must set Pr.13-02 and
Pr.03-22 (Reverse Pulse Logic) simultaneously.
Elevator Rated Frequency
Default: 60.00
Settings 0.00–400.00 Hz
 Sets this value according to the motor nameplate. In general, set this value equal to motor's rated
frequency.
 Sets the drive’s maximum operating frequency range.
The formula is: Pr.13-03 = (Pr.13-09 Number of Motor Poles × RPM when elevator runs with
rated speed) ÷ 120
Motor Rated Frequency
Default: 60.00
Settings 0.00–400.00 Hz
 Sets this value according to the motor nameplate. If the motor is 60 Hz, set this parameter to 60.
If the motor is 50 Hz, set it to 50.
Motor Rated Voltage
Default: 440.0