E
F
A
B
Assembly instructions
HL6002/HL6500
Smartphone
Holder
x1 — Phone Holder
x1 — Bungee
x1
— Handlebar Clamp
x1
— 360° Mount
x2 — Rubber Shim
x1 — Thumb Screw
x1 — Short Bolt
x1 — Stem Mount
x6 — Foam Inserts
Parts
A
B
C
D
E
F
G
H
I
Tool Required
Phillips Head Screwdriver
WARNING
Using phone device while riding can cause accidents resulting in serious injury.
Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device fits snugly in the holder before riding.
Not for off-road use.
STEM MOUNT OPTION
HANDLEBAR CLIP OPTION
H
I
G
Assembly video
Visit designbydelta.com/downloads
STEM BOLT
1
2
1
2
Using the Stem Mount
Remove existing stem cap from bicycle. Use existing stem bolt to install
Smartphone Holder stem mount (Part H) on to your bicycle stem.
NOTE:
for
landscape orientation
install the stem mount as shown in
FIGURE 1
Connect phone holder to stem mount using short bolt (Part G) and
adjust angle before full tightening. If necessary use the adhesive foam
inserts (Part I) to provide a snug fit for your device. (FIGURE 2)
C
Open slightly in order to allow
easy access to insert the bolt.
Insert the bolt on the same side
as the locking mechanism
IMPORTANT SAFETY NOTE
Never loosen the stem clamp bolts.
D
FIGURE 2
FIGURE 1
(for landscape
orientation)
