Delta DVS-328 series, Руководство пользователя

Страница: 151 / 246

D V S M a n a g e d I n d u s t r i a l R a c k Mo u n t E t h e r n e t S wi t c h U s e r Ma n u a l
3 - 1 3 0
3.14 Auto Warning
Industrial Ethernet devices in an industrial environment are very important. These devices usually need to work
for a long time and are usually located at the end of the system. So if the devices which connect to the industrial
Ethernet switch need to be maintained, the switch must provide some messages for the maintainer. Even when
the maintainers or the engineers do not stay in the control room, they still need to be informed of the status of
the devices. The Delta switch provides different approaches that can warn engineers automatically. In this
section, you can get the information about a relay alarm.
3.14.1 Relay Alarm
A relay alarm is used to monitor power, DI, the port status and redundancy. You can configure the power, DI,
redundancy and the port link or the traffic overload alarm event to notice related engineers.
3.14.1.1 Relay Alarm Setting
The Delta switch provides flexible configuring items for you to configure events according to your requirement.
If an event happens, it will trigger a relay alarm.
IMPORTANT :
Make sure that you save the configuration in the Save Configuration
page after you have applied the configuration changes. (Save
Config

Save Configuration) If you do not save the configuration,
then the configuration will be cleared after the switch is rebooted.