Delta CS-NT24, Руководство пользователя

Страница: 10 / 21

7
4. Cable tester
4.1 UTP cable test
Connect the network cable into the cable tester’s RJ45 port, the BNC cable or RJ11 telephone line connect to the
cable tester’s BNC or RJ11 port. If no connector cable, can use alligator clips to clip the bare copper wire.
Press key to select the “SCAN UTP” function, press the key to enter cable tracer interface.
4.1.1 Cable tracer
The UTP mode and STP mode can be optional. The UTP mode is for searching the normal cable or other cable.
The STP mode is for searching shielded cable.
Turn on the wire receiver, can search cable. Rotating the knob of receiver to adjust the sensitivity. When the cables
are very close, can adjust to the small sensitivity to find the cable.
Long press the “MUTE” key for silent mode. In this mode, the signal strength indicator light is used to trace the wi
re. When received the strongest signal, the eight indicator lights are on. Press “MUTE” again to exit MUTE
mode.
(1) Quickly verify the tracking result (only for RJ45 port).
After found the cable, connect the network cable to wire receiver “UTP” port for pair line detection. For example,
When the "Straight/Cross/Other" lights up, indicates the verification of the matching cable. The indicator also
shows the type of the cable. The 1-8 and G indicators show the detection of line sequence by default, and the order
in which the indicator lights up is the sequence of the line.
(2) Port continuity detection:
Connect the network cable into the cable tester’s RJ45 port, the other end of network cable to cable tester’s RJ45
port. Press “MUTE” button, when the indicator light of port is on, the 1-8 and G indicator lights will show the