v1.0.1
30
4
Operation
Turn on the upstream breaker. The indicator flashes in yellow during a system self-test. After the self-test
completed, the indicator illuminates in blue and the EVSE is ready to charge.
4.1
Start charging
1. Connect the vehicle connector to vehicle inlet.
2. Place the RFID card over the sensor area to initiate the charging process.
Note:
a. Successful card detection is indicated by two short beeps. A long beeping sound indicates authentication
failure. Please check your card and try it again.
b. The EVSE returns to standby mode if the vehicle connector is not connected to the EV within 60 seconds
after card authentication.
3. The indicator flashes blue to indicate the charging is initiated.
4.2
Stop charging
1. Stop charging session at the vehicle or swipe the RFID card again to stop the charging process.
2. Disconnect the vehicle connector from the vehicle inlet.
Note: the plug would be locked by the EV and please unlock the plug if needed.
3. Recover the vehicle connector to vehicle connector inlet.
5
LED Indicator
Status
Description
Black
Power off.
Yellow, fast flashing
Initial configuration and self-test.
Blue
Standby mode (not connecting to EV).
Yellow
Ready to charge (connecting to EV).
Blue, slow flashing
Charging in progress.
Green
Charging process completed or network connection success.
Yellow, 1 Flash
Network connection fail
Yellow, slow flashing
Limited output power by OCPP command, firmware upgrade or log
download.
Red, slow flashing
Refer to fault event.
Red
Failed self-test, general malfunction
