Delta 46-462, Руководство пользователя

Страница: 1 / 8

1
46-462 MIDI-LATHE STAND
N039884 - JULY09 - REV0
FoR UsE oNLY with DELta miDi-LathEs 46-455 aND 46-460
Fig. 3
E
IF YoU HAVE ANY QUESTIoNS oR CoMMENTS ABoUT THIS oR
ANY DELTA MACHINERY ACCESSoRY, CALL US ToLL FREE AT
800-223-7278.
SAFETY INSTRUCTIoNS
To reduce the risk of injury, read the tool instruction
manual before using any accessory. Failure to heed these warnings
may result in personal injury and serious damage to the tool and
the accessory. When servicing this tool, use only identical replace-
ment parts.
To reduce the risk of injury, turn tool off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. an accidental
start-up can cause injury.
To reduce risk of injury, this product should only be
used with Delta midi-lathes 46-455 and 46-460.
46-462 PARTS (FIG. 1, FIG. 2)
a. 3/8-16 nylock nut (12)
B. 3/8-16 x 1-1/2" (38 mm) hex head bolt (4)
C. 3/8-16 x 3-1/2" (89 mm) hex head bolt (8)
D. 3/8 flat washer (24)
E. Leveling foot with jam nut (4)
F. Lathe stand platforms (2)
g. Cross brace / tool holder
h. stand leg assemblies (2)
ASSEMBLY
NoTE: For ease of alignment, do not fully tighten bolts and nuts
until assembly is complete.
1. make sure jam nut (i) Fig. 3 (inset) is on the four rubber leveling
feet as shown.
2. screw in four rubber leveling feet (E) Fig. 3 into stand leg
assemblies. tighten all the way down. height can be adjusted
later.
3. attach left leg assembly (h) Fig. 4 and 5 to cross brace/tool holder
(g) oriented as shown using two 3/8-16 x 3-1/2" (89 mm) hex head
bolts (C) Fig. 4, two 3/8 flat washers (not shown) and two 3/8-16
nylock nuts (a) Fig. 4 in top and bottom holes only. a bolt is not
required in the center hole. make sure the stand's feet are oriented
away from tool holder (g) as shown in Fig. 5.
4. For both holes, place washer (not shown) on bolt and insert hex
head bolt (C) Figure 4 into the leg from the outside and then through
the hole in the tool holder. Place a second washer (not shown) on
bolt and fasten with the nylock nut (a).
h
g
Fig. 4
C
a
a
Fig. 5
g
h
a
B
C
D
E
Fig. 1
Fig. 2
F
g
h
i