User’s Manual
52
The available options for Onboard FDD Controller are :[Enabled] [Disabled].
Onboard Serial Port 1 / Port 2
Select a address and corresponding interrupt for the first and second serial ports.
The available options for Onboard Serial Port 1 / Port 2 are : [Auto] [3F8 /
IRQ4] [2F8 / IRQ3] [3E8 / IRQ4] [2E8 / IRQ3] [Disabled].
UART 2 Mode / IR Function Duplex / TX, RX inverting enabled
Select an operating mode for the onboard serial port 2. If you select [HPSIR] or
[ASKIR], the IR Function Duplex and TX, RX inverting enable items will appear.
z
The [HPSIR] is Hewlett Packard infrared communication protocol with maxi-
mum baud rate up to 115.2k bps.
z
The [ASKIR] is Sharp infrared communication protocol with maximum baud
rate up to 57.6K bps.
The available options for UART 2 Mode are : [Standard] [HPSIR] [ASKIR].
Onboard Parallel Port
Allows you to determine onboard parallel port controller I/O address setting.
The available options for Onboard Parallel Port are : [378 / IRQ7] [278 / IRQ5]
[3BC / IRQ7] [Disabled].
Onboard Parallel Port Mode / ECP Mode Use DMA / Parallel Port EPP Type
Select an operating mode for the onboard parallel port. Select [Normal] un-
less you are certain your hardware and software both support one of the
other available modes. If you select other mode, the ECP Mode Use DMA
and Parallel Port EPP Type items will appear.
z
z
z
z
z
[SPP]
:
Standard Parallel Port is the IBM AT and PS/2 compatible mode.
z
z
z
z
z
[EPP]
: Enhanced Parallel Port is enhances the parallel port throughput
by directly writing / reading data to / from parallel port without latch.
z
z
z
z
z
[ECP]
: Extended Parallel Port is supports DMA and RLE (Run Length
