DELTA DORE TYMOOV 10RE2, Быстрый старт

Страница: 15 / 16

EN
28 29
15/ Setting stops from the push button (local
control)
15.5 Removing stops
+
> 3s
< 5s
x 2
OFF
ON
> 2s
OR
• If the motor is not working:
- Check that the wiring corresponds to the diagrams in the “Connection” chapter.
- Check the power supply in the network.
- Check that the motor is not in thermal protection mode; just wait a few minutes for
it to cool down.
- Check whether there is a problem linked to the end of travel settings and
reset them.
• The end of travel points are not applied:
- Check the mechanical components of the system (stabilisation, play, distortion, etc.)
- Check whether there is a fault linked to the end of travel settings and reset them.
• The green LED does not flash after briefly pressing button B.
- Several motors are associated with the remote control.
Therefore, you cannot access the setting modes in this case.
The remote control must only be associated with one motor for the settings.
• To find out the type and version of the motor used.
- Position the shutter in an intermediate position (neither open nor completely
closed).
- Press the STOP button on the remote control 3 times:
The motor operates twice (
x 2
x 1
)
TYMOOV xRP2 and DxRP2
(software version S02.04.00 and higher)
The motor operates once (
x 2
x 1
)
TYMOOV xRE2
(software version S02.04.00 and higher)
The motor does not respond
TYMOOV xRE2 or xRP2 or DxRP2
(software version < S02.04.00)
See label on the motor
17/ Troubleshooting
Press the push button once to move the shutter
down or up.Switch off the mains within 5 seconds
after the motor reaches the upper or lower stop
position. Wait for at least 2 seconds, then switch on the
motor again, while pressing down nd holding the
push button for more than 3 seconds.
Wait for the motor to operate twice before
releasing the push button.
The stops have now been removed.
To return to the original configuration (so that the motor has no associated
transmitter):
To carry out a factory reset, the remote control must be associated to one motor
only.
> 3s
x 2
16/ Factory reset
Press button B on the front
panel of the remote control
twice
, until the LED flashes
orange.
Press and hold the
button for more than 3 seconds
until the red LED comes on.
The motor is briefly
activated twice.
Then the motor is activated
once. It means it is in
association waiting.
The motor will now have no
associations or settings