Delphin ProfiMessage, Руководство по оборудованию

Страница: 97 / 322

Profi Message
4.7.2 Operating hours counter
This software channel registers the time period during which the source has an
active level. When the level becomes inactive, the time period is added to the exist-
ing time period.
High level / Low level : Sets the active level of the source.
The operating hours counter retains its value even when the scale is
altered.
Enable Reset and configure a channel and the trigger ( edge , level ) to reset the
operating hours counter.
Refer also to
Trigger options .
If the source has an active level when the reset signal occurs, the operating hours
counter is reset to zero only after the source becomes inactive again.
4.7.3 Differentiator
This software channel calculates the ratio of the difference between two values
from the source channel to the difference between their time stamps in relation to
the time base:
Differential = ( Δ value / Δ timestamp) * time base
Refer also to the Additional Settings tab
Time base : Enter the time base for the calculation. The default is 1000 ms.
Enable the Trigger if the calculation is to be triggered by specific events. The dif-
ferential between successive trigger events is then calculated.
Refer also to
Trigger options .
4.7.4
Event
Dialog ist noch nicht beschrieben! Beschreibung folgt in Kürze.
4.7.5 Flip-flop
This software channel functions as a hardware flip-flop.
Select the type of flip-flop in the Mode field. A diagram is displayed depending on
the selection. Various inputs are available. Disable any unnecessary inputs.
97
Delphin Technology AG
Dezember 2015
Profi Message Manual