background image

4

heater. Plugging heater  into a worn outlet /receptacle/ may result in overheating of the power

cord or fire.

17. Do not use an extension cord because the extension cord may overheat and cause a risk

of fire. However, if you have to use an extension cord, the cord shall be  Ul listed No. 1 4 AWG

minimum size and rated not less than 1 875 watts, ISAMP at 125 V and has to be used only

for supplying power to this heater.

18. Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that

receptacles also deteriorate due to aging and continuous use: check periodically if signs

overheating or deformations are evidenced by the plug. Do not use the receptacle and CALL

your electrician.

19. Check that neither the appliance nor the power cable have been damaged in any way

during transportation.

20. Before connecting to electric power outlet, check your electrical power supply. It must be

120 volts A.C. (alternating current). The outlet may be 15 amp. or 20 amp. The circuit must

be of adequate size and must be protected by fuse or circuit breacker. DO NOT place heater

directly beneath electrical receptacle and DO NOT place heater against paper board or low

density fiberboard.

DO NOT touch hot surfaces.

DO NOT immerse cord, plug or heater in water or othet liquid, or pour this will cause

dangerous electrical conditions and potential electrical shock.

DO NOT obstruct the top or bottom air openings.

Dust and lint on the heating element can obstruct the free flow of air. DO NOT operate when

so obstructed.

Operating with air openings obstructed could cause a dangerous condition.

22. Make sure that no pieces of polystyrene or other packaging material have been left into the

appliance. It may be necessary to pass over the appliance with a wacuum cleaner.

23. When switching on the appliance for the first time, allow it to run at full power for about 1

hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is

located is well ventilated during this operation.

24. It is not advisable for the appliance to be positioned where it is exposed to draughts which

might prevent it from  working properly.

SAVE THESE INSTRUCTIONS

Содержание HS15F








Отзывы: