3
GENERAL INSTRUCTIONS
Remove the heater from the packaging. Check that neither the heater nor the power cable has been damaged during transport.
Do not operate the heater if damaged.
Your convector is suitable for either freestanding or wall mounting usage. Do not assemble the feet if wall mounting.
ASSEMBLING THE FEET
To fit the feet to the appliance, proceed as follows:
Insert the foot into the slot at the side and push it in all the way until it hooks onto the two teeth (Fig. 1).
WALL-MOUNTING
IMPORTANT:
Before drilling into any wall ensure no electrical cables are present in the area.
In order to wall mount your convector please proceed as follows:
1. Fix two brackets “A” following carefully the dimensions as indicated in figure 2. Use a 6 mm masonry drill and suitable wall
plugs and 2 x No 8 screws (minimum length 25 mm).
2. Hang the convector on the two brackets fixed to the wall and insert metal brackets “B” into the bottom rear section of the
base of the convector as indicated in figure 3, one at each end.
Mark the positions for fixing these brackets to the wall.
This bracket when fixed retains the base of the convector in a fixed position, preventing removal.
3. Remove the convector heater from the hanging brackets and drill the wall for 2 x suitable wall plugs and insert them.
4. Fit the convector to the 2 brackets “A”. Insert Brackets “B” to the convector base and fix brackets “B” to the wall plugs by
means of 2 x No 8 screws ( minimum length 25 mm).
Your convector is now wall mounted.
The appliances should not be installed directly under a wall power socket.
Do not use your heater in a bathroom.
The appliance should not be installed immediately below a permanent mains outlet.
Position the appliance so that the plug and the socket can be easily reached even after installation.
ELECTRICAL CONNECTION
-
Before plugging the appliance into the mains, check that your supply voltage is the same as that shown on the rating plate
of the appliance.
-
If using more than one appliance at a time, it is important to ensure that the ring main is adequate to cope with the power
requirements.
-
This appliance complies with EEC Directive 89/336 relating to electromagnetic compatibility.
The wires in the mains lead are coloured in accordance
with the following code:
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead may not correspond
with the coloured markings identifying the terminals in your plug,
proceed as follows:
The blue wire must be connected to the terminal marked with the
letter N or coloured black.
The brown wire must be connected to the terminal marked with the
letter L or coloured red.
I
f you have a 3-pins plug, do not connect any wire to the “earth”
terminal.
ELECTRICAL CONNECTION (U.K. ONLY)
A) If your appliance comes fitted with a plug, it will incorporate a
13 Amp fuse. If it does not fit your socket, the plug should be
cut off from the mains lead, and an appropriate plug fitted, as
below.
WARNING: Very carefully dispose of the cut off plug after removing
the fuse: do not insert in a 13 Amp socket elsewhere in the house
as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit
must be protected by a 15 Amp fuse.
If the plug is a moulded-on type, the fuse cover must be re-
fitted when changing the fuse using a 13 Amp Asta approved
fuse to BS 1362. In the event of losing the fuse cover, the
plug must NOT be used until a replacement fuse cover can
be obtained from your nearest electrical dealer. The colour of
the correct replacement fuse cover is that as marked on the
base of the plug.
B)
If your appliance is not fitted with a plug, please follow the
instructions provided below:
5713003700 11-06-2002 14:03 Pagina 3
