-
To set the program
B
press “Timer button
B
” and follow the same procedure as
described for the program
A
.
-
Use the “
+
” or “
-
” buttons to set the desired comfort tempera-
ture, as described above.
-
When set in this way the heater will automatically switch on at the
set time for the designated time period and automatically maintain
the preset comfort temperature.
To cancel a preset program, press the timer button
A
or
B
once and then press the
hour button until the display shows “--:--“ (fig.3).
TIMER OVERRIDE
To operate the appliance without using the programs (timer), press the “ON MODE” button
(Fig.2). The yellow lamp “ “ will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does not switch
on. The display shows the blinking numbers. To switch it on, repeat the above described ope-
rations.
Remote Control
The appliance can be completely controlled with the remote control. Two AAA 1.5V batteries
are required (not included):
• remove the cover located on the back side of the remote control;
• insert the two AAA 1.5V batteries positioning them correctly (see the instructions in the
batteries compartment);
• replace the cover.
Remote Control Operation
- When you press the frost protection push button, the radiator will set the temperature to
42°F (5°C) and will switch on automatically only if the room temperature falls below 42°F
(5°C), thereby preventing freezing, at minimum energy consumption.
The “ “ light on the control panel will flash.
- Press the increase/decrease temperature button (+/-) to adjust the temperature from 42°F
(5°C) to 95°F (35°C).
- The “Off” button switches off the appliance.
Every time you press a button, the appliance will confirm the selection with a “beep” and
the pilot light on the remote control will illuminate.
WARNINGS
You must leave the heater plugged into the outlet to keep the timer
memory programmed.
If the heater loses its power supply for more than 2 minutes, (e.g. switched off at the outlet or
in the event of a power failure), the heater’s programs will be lost, and the heater will not
work until reset.
6
+
-
fig. 3
