37
INSIDE OF OVEN
■
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after first consulting with the
manufacturers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cavi-
ty surface.
■
NOTE:
The manufacturers of this appliance will accept no responsibility for dam-
age caused by chemical or abrasive cleaning.
■
Do not store flammable material in the oven.
ADVICE FOR USE AND MAINTENANCE OF CATALYTIC
PANELS
The catalytic panels are covered with special microporous enamel which absorbs and
does away with oil and fat splashes during normal baking over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven “idling” on
max temperature for about 30 minutes. These panels do not require to be cleaned,
however it is advised to periodically remove them from the oven (at least the side pan-
els) and to wash them with tepid soapy water and then wipe off with a soft cloth.
DO NOT CLEAN OR WASH THEM WITH ABRASIVE PRODUCTS OR WITH
PRODUCTS CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when the catalytic microporous enamel degrades,
they can be turned to the other side.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains
.
When the oven is cool, unscrew and replace the bulb with another one resistant to
high temperatures (300°C), voltage 230-240 V~ (50 Hz), E14 and same power (check
watt power as stamped in the bulb itself) of the replaced bulb.
Note:
Oven bulb replacement is not covered by your guarantee.
GRILL HEATING ELEMENT
The heating element is self-cleaning and does not require maintenance.
GAS TAPS
If the gas taps are not working properly, call our Customer Service Centre to obtain the
nearest Authorized Delonghi Service Agent.
