a.
b.
3.
Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory
module from its connector.
Installing the Memory module
NOTE: Please use DIMM 2 slot if there is only one memory module available.
1.
Align the notch on the memory module with the tab on the system-board connector.
2.
Press down on the memory module until the retention clip spring back to secure them in place.
3.
Install:
a.
b.
4.
After Working Inside Your Computer
Removing the Heatsink
1.
Before Working Inside Your Computer
.
2.
Remove:
a.
b.
3.
Remove the screws that secure the heatsink to the system board [1,2,3,4,5,6,7].
NOTE: Loosen the screws in the order of the callout numbers [1, 2, 3, 4, 5, 6, 7]. Except for
screw [7], the rest of the screws are retention screws and cannot be fully removed.
11
