Dell Vostro 15 7510, Руководство по обслуживанию

Страница: 46 / 85

4. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three (M2x1.8) and two (M2x3) screws that secure the touchpad bracket to the palm-rest and keyboard
assembly.
6. Slide the touchpad cable into the connector on the touchpad and close the latch to secure the cable.
7. Adhere the tape that secures the touchpad bracket to the palm-rest and keyboard assembly.
8. Adhere the tape that secures the speaker cable to the touchpad.
Next steps
1. Install the battery .
2. Install the base cover .
3. Follow the procedure in After working inside your computer .
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Enter Service Mode .
3. Remove the base cover .
4. Remove the heat sink .
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
46 Removing and installing components