Dell SD630-S, Руководство пользователя

Страница: 128 / 163

Control panel assembly
Removing the control panel board–eight hard drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the
locking tab on the connector is released before removal and insertion. The locking tab must be
engaged after insertion.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #2 screwdriver ready.
Steps
1.
Disconnect the control panel and display module cables from the control panel board.
2. Remove the two screws that secure the control panel board to the chassis.
3. Slide the control panel board toward the back and out of the system.
Figure 61. Removing the control panel board
1. control panel board 2. screws (2)
3. control panel cable 4. display module cable
128