Version
Description
8.3.7.0
Introduced on the S4810.
Legacy E-Series
command.
Usage Information
FEFD disable
command on the interface prevents the interface from running FEFD when FEFD is enabled
globally.
Related Commands
•
— clear an interface in Err-disabled state. It doesn’t work until the interface is in err-disabled state.
•
— change FEFD mode on an interface.
fefd interval
Set an interval between control packets.
Syntax
fefd interval
seconds
To return to the default value, use the
no fefd interval
command.
Parameters
seconds
Enter a number as the time between FEFD control packets. The range is from 3 to 255
seconds. The default is
15 seconds
.
Defaults
15 seconds
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
Legacy E-Series
command.
Usage Information
You can set up the interval between control packets using the
fefd interval
command.
Related Commands
•
— enable far-end failure detection.
948
Layer 2
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...