Dell S6100, Руководство по настройке

Страница: 945 / 1743

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
Untagged interfaces can only belong to one VLAN.
In the Default VLAN, you cannot use the
no untagged interface
command. To remove an untagged
interface from all VLANs, including the Default VLAN, enter INTERFACE mode and use the
no switchport
command.
Related Commands
• interface vlan — configure a VLAN.
• tagged — specify which interfaces in a VLAN are tagged.
Far-End Failure Detection (FEFD)
The Dell Networking operating software supports far-end failure detection (FEFD) on the Ethernet interfaces of the platform.
The FEFD feature detects and reports far-end link failures.
• FEFD is not supported on the Management interface.
• During an RPM failover, FEFD is operationally disabled for approximately 8 to 10 seconds.
• By default, FEFD is disabled.
debug fefd
Enable debugging of FEFD.
Syntax debug fefd {events | packets} [ interface ]
To disable debugging of FEFD, use the
no debug fefd {events | packets} [ interface ]
command.
Parameters
events Enter the keyword
events
to enable debugging of FEFD state changes.
packets Enter the keyword
packets
to enable debugging of FEFD to view information on
packets sent and received.
interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
Command Modes EXEC Privilege
Layer 2 945