show mac-address-table
Display the MAC address table.
Syntax
show mac-address-table [address
mac-address
| interface
interface
| vlan
vlan-
id
] [aging-time] [dynamic | static] [count [vlan
vlan-id
] [interface
interface-
type
[
slot
[
/port
[
/subport
]]]]]
Parameters
address
mac-
address
(OPTIONAL) Enter the keyword
address
then a MAC address in the nn:nn:nn:nn:nn:nn
format to display information on that MAC address.
dynamic
(OPTIONAL) Enter the keyword
dynamic
to display only those MAC addresses the
switch dynamically learns. Optionally, you can also add one of these combinations:
address/
mac-address
,
interface/
interface
, or
vlan
vlan-id
.
static
(OPTIONAL) Enter the keyword
static
to display only those MAC addresses
specifically configured on the switch. Optionally, you can also add one of these
combinations:
address/
mac-address
,
interface/
interface
, or
vlan
vlan-
id
.
aging-time
Enter the keyword
aging-time
to display only aging-time information.
interface
interface
(OPTIONAL) Enter the keyword
interface
and the interface information:
•
For a port channel interface, enter the keywords
port-channel
then a number.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
interface
interface-
type
(OPTIONAL) Instead of entering the keyword
interface
then the interface type, slot/
port[/subport] information, as above, you can enter the interface type, then just a slot
number.
vlan
vlan-id
(OPTIONAL) Enter the keyword
vlan
then the VLAN ID to display the MAC address
assigned to the VLAN. The range is 1 to 4094.
count
(OPTIONAL) Enter the keyword
count
, then optionally, by an interface or VLAN ID, to
display total or interface-specific static addresses, dynamic addresses, and MAC
addresses in use.
Command Modes
•
EXEC
•
EXEC Privilege
Layer 2
929
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...