Dell S6100, Руководство по настройке

Страница: 837 / 1743

prefix-list-name Enter the name of a configured IP prefix list. Routes meeting the criteria of the IP Prefix
list are leaked.
Defaults level1-into-level2 (Level 1 to Level 2 leaking is enabled.)
level2–into-level1 (Level 2 to Level 1) leaking is disabled.
Command Modes
• ROUTER ISIS ( for IPv4 )
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 ( for IPv6 )
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added IPv6 ISIS support.
6.3.1.0 Version 6.3.1.0 Introduced
Usage Information
You cannot disable leaking from Level 1 to Level 2. Also, you cannot enable leaking from Level 2 to Level 1. However,
you can regulate the rate flow from one level to another using an IP Prefix list. If you do not configure the IP Prefix
list, all Level 1 routes are leaked.
You can find more information in IETF RFC 2966, Domain-wide Prefix Distribution with Two-Level IS-IS .
area-password
Configure a hash message authentication code (HMAC) password for an area.
Syntax area-password [hmac-md5 | encryption-type ] password
To delete a password, use the no area-password command.
Parameters
hmac-md5 (OPTIONAL) Enter the keywords
hmac-md5
to encrypt the password.
encryption-type (OPTIONAL) Enter
7
to encrypt the password using DES.
Intermediate System to Intermediate System (IS-IS) 837